Base de Conocimiento

Back to Módulo Location

Slope Components 6

Updated May 09, 2016

This article applies to:
  • RoadEng Civil
  • RoadEng Forestry


This component creates up to 5 benches. The component can be applied in cut or fill or both. A closing slope can be included.

Typical Cross Section


bApplyInCutSet to 1 to apply this component when the connection point is in cut.
bApplyInFillApply component when the connection point is below stripped topo.
bCloseToTopoIf set to 1, a final slope will always be created to close to ground.
FinalCutSlpClosing slope in cut.
FinalFillSlpFinal closing slope in fill.
BenchSlopeBench slope.
BenchHeightHeight of the bench.
BenchBaseWidthWidth of bench.
BenchBaseSlopeSlope of the base (bottom) of the bench.