Base de Conocimiento

Back to Módulo Location

Slope Components 5

Updated May 09, 2016

This article applies to:
  • RoadEng Civil
  • RoadEng Forestry

Cut Slope by Depth Component

This component varies the slope based on depth of cut. Two depths are entered defining 3 possible slopes.

Typical Cross Section


bApplyInFillIf set to 1 the a cut slope (FinalFillSlp) will be applied when the connection point is above topo.
FinalFillSlpFinal fill slope. Only used if bApplyInFill is set.
CutDepth1Smallest cut depth.
CutDepth2Second cut depth. Should be greater or equal to CutDepth1.
CutSlope1Slope for cuts less than CutDepth1.
CutSlope2Slope for cuts greater than CutDepth1 and less than CutDepth2.
CutSlope3Slope for cuts greater than CutDepth3